A610 / GTA ABS Rings New

[stephendell]

A610 / GTA New ABS Rings.

Genuine OEM part.

Removed from new ABS drive shafts when fitted to non ABS cars.

Interference fit.

ABS Ring Single.JPG

ABS Ring Group Front.JPG

ABS Ring Group Back.JPG

£50 each members. (£60 each non members).

4 left.

Hi Stephen

If you still have these Rings, I would like a pair please.

I did PM you about them a few days ago, but I see that the message is still sitting in my Outbox for some reason! Don't know what's going on there. Anyway, hopefully you'll see this and get back to me.

Regards

Craig

Stephen,
I was after a pair a while ago, not sure why I missed the OP.
Please couls I have a pair too, for GTA.

[stephendell]

Sadly already all sold to Adam spence.

Typically I need some myself so looking at remanufacture.

I will check my mailbox. It may be full.

.
Hope you gave him free club membership as part of the deal then Stephen, a set of ebay rings grafted on to the CV joints case would have worked for Adam's need... I'm sure something like this could be adapted without too much work, press fit would be fine.

http://www.ebay.co.uk/itm/RENAULT-ABS-R ... SwknJXztnt

Grant the 610 ones have the shoulder, but I bet the other ones can be made to work. Looks like the majority ov the Renault ones are 44 teeth, but given the generation of the electronics, I bet the tooth count doesn't matter a fig, just the % difference in pulse rate being counted front to rear to establish skid...

[stephendell]

He got the members prices

No idea what his need is but seems there is no cheaper solution other than diy if looking to fit onto standard driveshafts as I have discovered when now trying to replace for myself

Just the materials and labour for time on the lathe to make an adaptor would cost more.

.
I presume then yours have given way to metal rot? I would try machining back to the base diameter, and press fit some fleebay jobs on as a sleeve, do all 4 so they are matched tooth count, should work fine... nowt to lose...

Martin

[stephendell]

.
I presume then yours have given way to metal rot? I would try machining back to the base diameter, and press fit some fleebay jobs on as a sleeve, do all 4 so they are matched tooth count, should work fine... nowt to lose...

Martin

Yes that could be worth a try!