Moderators: eastlmark, BIG_MVS, phildini, Test Moderator, Alpineandy
Non Member
982
Sun May 16, 2004 10:49 pm
Charlotte, USA
Non Member
5602
Thu Apr 15, 2004 12:33 pm
Fleet, Hampshire
Non Member
982
Sun May 16, 2004 10:49 pm
Charlotte, USA
Non Member
3474
Thu Apr 15, 2004 8:10 am
Colchester, Essex
Non Member
982
Sun May 16, 2004 10:49 pm
Charlotte, USA
Non Member
3474
Thu Apr 15, 2004 8:10 am
Colchester, Essex
Juzzblack wrote:Ok David, thanks. A couple more questions...
Where I've teed off, isn't it getting the pressure from the manifold before it reaches the dump valve? Or does it flow the other way?
And for testing, which one is the original gauge feed? The right hand one with the yellow band in my original picture?
And finally, if I try it wth a different feed and still get 0.4bar, should I adjust the actuator, or adjust using the upgrade valve which I'll be plumbing into the actuator feed?
Cheers.
Club Member
2381
Mon Jun 14, 2004 8:37 am
North Essex
David Gentleman wrote:If you still get 0.4 bar, yes, wind the actuator in till you get around 10-12, then do the rest with the valve.
Users browsing this forum: No registered users and 75 guests