Turbo2 valve Clearances

Hi all,

First post on here working on my newly imported1985 turbo2 this afternoon and found the valve clearances need adjusting,can anybody help me please with the correct settings for both inlet and exhaust....thanks in advance..James

I will have to look it up...try to do that this week.

Thanks Jochem,I've not progressed any further with this job as I have no tolerances as yet.... would be fantastic if you could let me know...

My manual says 0.3mm intake and 0.4mm exhaust (cold)

Trevor.

Thanks Trevor I've measured them all cold and the intake gaps range from 0.25-0.40 inlet and 0.40-0.70 on the exhaust side,I'll adjust these too the correct gaps which hopefully should quieten down the valve gear noise I'm getting..

The car is running very lumpy on 3 cylinders at the moment,it has good compression on all four so I suspect a fault with the fuel injection system.I gather the fuel system on the turbo2's can be a little tempermental.I trying to source a manual for the car but so far no luck whatsoever...

[BIG_MVS]

Hi all,

First post on here working on my newly imported1985 turbo2 this afternoon and found the valve clearances need adjusting,can anybody help me please with the correct settings for both inlet and exhaust....thanks in advance..James

Welcome! We need pictures of your new toy!

I may have a spare manual, I'll have a look. As Martin says, let's see some pictures.

Trevor.

Thanks for the welcome If you have a spare workshop manual Trevor that would be great! [img][img]http://img547.imageshack.us/img547/3025/renault5turbo2project00.jpg[/img]

Uploaded with ImageShack.us[/img]

Nice .... Mine is the same color.