New Turbo project

Sun has been out so a good day for spray .Slowly it is all coming together for some lucky person ...it could be you

Box done and sub-frame assembled .
Decision time on engine but I think I will throw the reverse headers ,down pipe etc from JIL on a 2.5 std bottom end but with modded heads and cams .
Adaptronic control .
JIL has gone to stage ..... on engine design anyway so all these bits are now spare for this car .
Found some good Koni rear dampers and lowering springs so they go on as well .

Car still remains for sale in any guise but I have to get on and clear the decks for others and a car in bits takes up 2 car spaces .....

Cams now here so the lump can finally be assembled .8mm lift with a 60trim .48 turbo should do the job .Reverse headers ?? Means using modified bellhousing and different starter motor setup ...
New front calipers + refurbed BIGG RED rears in the post .

Shiny things

.. far too shiny, I just gotta wear my shades .

BTW did you change the input shaft ok?

No , not looked at it yet .Need to get rid of some cars first .

Rear calipers back from Bigg Red So new calipers all round .
Total to refurb a pair only 149 delivered !! Couldn't do them yourself for that
One thing is irking me though but not enough to spend more money on