Moderators: eastlmark, BIG_MVS, phildini, Test Moderator, Alpineandy
Non Member
994
Tue Jul 20, 2004 12:14 pm
West Moors, Dorset
Non Member
2120
Sun Dec 02, 2007 6:19 pm
Jersey C.I.
Non Member
994
Tue Jul 20, 2004 12:14 pm
West Moors, Dorset
Non Member
994
Tue Jul 20, 2004 12:14 pm
West Moors, Dorset
Non Member
2120
Sun Dec 02, 2007 6:19 pm
Jersey C.I.
JohnC, am I correct in assuming that the three screws securing the speedo clock to rear holding bracket are there just as support ?...........Speedo woes, dont you just love um...
Non Member
994
Tue Jul 20, 2004 12:14 pm
West Moors, Dorset
Non Member
994
Tue Jul 20, 2004 12:14 pm
West Moors, Dorset
Non Member
2120
Sun Dec 02, 2007 6:19 pm
Jersey C.I.
But I was wondering what the other two screws purpose are on the side of the mechanism - shown in John's photo above.
JohnC wrote:
Non Member
994
Tue Jul 20, 2004 12:14 pm
West Moors, Dorset
Non Member
2120
Sun Dec 02, 2007 6:19 pm
Jersey C.I.
pgoldsmith wrote: ....... However, what about the rev counter ? Mine occasionally decides to either stay on zero and not move at all. Or it moves albeit very slowly and doesn’t react quickly to changes in engine speed. Also, it has been know to stay stuck on , say, 2000 RPM even when the engine is switch off !
Users browsing this forum: No registered users and 122 guests