Moderators: eastlmark, BIG_MVS, phildini, Test Moderator, Alpineandy
Non Member
2501
Wed Apr 14, 2004 10:26 pm
Cumbria
Non Member
3709
Mon Apr 18, 2005 7:11 am
Alpine France
peterg wrote:After my unfortunate engine decided to give up the ghost I am in the early staged of re-building it. The turbo has gone off for a refurb and a bigger compressor housing to flow more air(so I can do it all again after a few more RR sessions ).
The engine is stripped down to the heads and block now.....it hasnt been too hard so far, I just seem to have a lot of bits in boxes! I hope I can remember where they all go
The heads will be coming off tomorrow so I will know for sure whats wrong, but at the minute its assumed to be piston rings. New rings, big ends, valve stem oil seals and gaskets are on their way (hopefully!!!) from Mecca parts in France. I need it up and running again before the wedding on 1st September.......if I have to take the Pug 205 to my last 2 events I may throw away another championship
Non Member
1514
Tue Apr 12, 2005 12:24 am
Nr Chippenham, Wiltshire
Non Member
2501
Wed Apr 14, 2004 10:26 pm
Cumbria
Non Member
3709
Mon Apr 18, 2005 7:11 am
Alpine France
Non Member
5602
Thu Apr 15, 2004 12:33 pm
Fleet, Hampshire
Non Member
725
Thu Apr 14, 2005 9:06 am
Hampshire
Non Member
2501
Wed Apr 14, 2004 10:26 pm
Cumbria
Non Member
5602
Thu Apr 15, 2004 12:33 pm
Fleet, Hampshire
Non Member
3709
Mon Apr 18, 2005 7:11 am
Alpine France
Users browsing this forum: No registered users and 215 guests