This'll scare the neighbours ....

by **clee** » Fri May 28, 2010 2:43 pm

Smokin

by **simontaylor** » Fri May 28, 2010 4:47 pm

..... and smiling :!:

by **clee** » Mon Jun 28, 2010 4:10 pm

....out again and on the lookout for a clutch that's man enough ......That paddle will not work without a fair few mods .
I'm off down to see an outfit this week that can help hopefully .Then it's T04E HongKongPhooey Turbo and some 440cc....#
Shhh now ! not a word to Me-Dawny :wink:

by **Stunned Monkey** » Tue Jun 29, 2010 11:53 am

Ave a word with Kevin at GTO...

by **stephendell** » Wed Jun 30, 2010 12:34 am

Saw a very nice helix 6 paddle with springs destined for a venturi with the one piece shaft mods today.

by **clee** » Wed Jun 30, 2010 7:06 am

Sure it was Helix and not AP Racing ??
Went to see a clutch man yesterday , he mentioned a Venturi they had just supplied .
I am looking at two options at the minute .
AP cover ,6 paddle and thrust bearing .Only problem is I need to machine the flywheel and also make up a bearing carrier as well to accept and I'm running out of time .....
Or just go with the paddle and master cover or Ferry do a paddle I think .

by **MFaulks** » Wed Jun 30, 2010 12:43 pm

What happened to the exhaust wrap, or was that just one side? Forgotten now

by **clee** » Wed Jun 30, 2010 12:44 pm

Just did it around the starter .Will finish it off now I know it works

by **stephendell** » Thu Jul 01, 2010 11:09 pm

Yes, definately said Helix, unless they out-sourced part of it.

by **clee** » Tue Jul 06, 2010 5:18 pm

Yep it was Helix ,special jobby innit .

Anyroad up ......Been and done and got the new clutch .A few fettles and it'll be in so that's a weight off and means I can crack on :twisted:

by **simonsays74** » Tue Jul 06, 2010 5:23 pm

Looks good fella!

'Many pounds for that?

by **clee** » Tue Jul 06, 2010 5:31 pm

Nope ...under the 610 list price ...well not the one Dellboy gets for the Clique boys :lol:

+ I got a discount on the price he quoted me last week without any prompting

£400 ish before the dreaded for the 3 parts .I need to get the step off the fly and also redrill the dowels etc .Modded the std bearing carrier to accept new thrust already and the overall heights are nearer std GTA than the master setup and that worked fine .