Intake manifold

Question for DG,(seeing as though my engine thread got hijacked)!!

I am planning to use the Z7W heads on my project engine.If i go single turbo route what intake manifold can i use??

A610 or standard Z7W inlet manifold.

A610 would be best?
Any idea how much?
What size throttle body does it?

Sorry bout the many questions!!!

Nope, the standard Z7W manifold is far better, but you can't use it if you keep the turbo in the original position (unless....you ditch the water pump, run an electric one, then you can flip the manifold round 180 degrees.

Both have the same 55mm throttle body.

A610 inlet manifold is about £350, if they have 'em..

Ok,thanks for that DG.

Any ideas where i may be able to pickup a Z7W intake??

???? Dunno if this is any use ?
http://cgi.ebay.co.uk/renault-V6-3-litr ... dZViewItem

Have seen it thanks lee.
It looked good if i were going the twin turbo route but i have decided to go single.

Anyway the chap said if he doesn't sell the engine complete he will keep it for himself!!!